MAG4000

(1 customer review)

$2,195.00

A powerful oxy-flame cutting kit generating an incredible ten-thousand degree particle stream for performing serious work in short order. With the speed four times that of oxyacetylene 4″ plates can be pierced in as little as four seconds. Further, a linear foot of weld can be removed in eight seconds. Stress cracks can be gouged and pins pierced using oxygen alone. Bucket hooks lopped off up to 12″ in less than sixty seconds.

Equipment service personnel find this a very handy service tool for removing stubborn equipment pins. Operators can easily gouge stress cracks, lop off bucket hooks, remove hard-facing and much more using a flame process. It eats rust, scale, paint and slag. There is no need for surface preparation or preheating. From humble sugar plantations running 24/7 to removing nuclear reactor cooling towers, our oxygen driven flame process will surprise you at how a mere change in hand position can dramatically change the way you approach solving problems.

Recommended accessories include extenders for piercing long pins and portable battery ignition systems which eliminate cables. Enjoy ten thousand degrees of unstoppable cutting and piercing power at your fingertips using oxygen alone. We designed the torch for Navy Seals breaching cargo doors. Torch accommodates 18″ or 36″ consumables.

Compare

Description

Instructional Video

MAG4000 Land cutting kit.

Ships with the following:

Magnum top valve cutting torch.

Oxygen hose, 15′ R rated 200 psi burst.

CGA 540 precision oxygen regulator.

Cable ignition, 15′ for 12 volt DC source.

MAG3818 Blade 3/8 x 18″ cutting rods, 50 per box.

Spare torch head and 3/8″ collet.

Online instructional video (see videos link).

UPS 2 packages (one for system and one for cutting rods).

40 lbs approximate.

 

MAG4000+ Ships with MAG3836 cutting and piercing rods size 3/8 x 36″. Approximate weight for two boxes, 82 lbs total.

One of our best sellers. Features include speed, power and versatility. Used for repair, maintenance, scrap, dismantling and salvage. Takes five minutes to set up and seconds to change rods for expedient problem solving in both shop and field settings.

1 review for MAG4000

  1. PAUL RUETER

    I HAD A 3INCH IN DIAMETER PIN IN A D4H DOZER THAT WE COULD NOT REMOVE AFTER USING THE MAG 4000 IT TOOK 15 MINUTES TO REMOVE COMPLETE PIN THIS TOOL IS AWESOME WOULD RECOMEND IT TO ANYONE

Add a review

Your email address will not be published. Required fields are marked *

X